Blog

  • The Edge Banding Didn’t Fail. The Particleboard Edge Killed Both.

    The Edge Banding Didn’t Fail. The Glue Didn’t Fail. The Particleboard Edge Killed Both — and Your Glue-Line Test Can’t See It Coming.

    I pulled a three-year-old kitchen base cabinet out of a coastal apartment last spring. The PVC edge band was still attached along most of the run. But within 150 mm of the sink cutout, the band lifted cleanly off the substrate, and the particleboard underneath had swelled enough that you could feel the step with a fingernail. The glue line looked fine where the band was still down. The band itself was intact. The adhesive hadn’t degraded. What failed was the edge of the board — and the specification that treated edge banding as a product rather than a system with a moisture path running through it.

    (more…)

  • Why Your PVC Edge Banding Starts Peeling After 6–8 Months in Humid Workshops

    Why Your PVC Edge Banding Starts Peeling After 6–8 Months in Humid Workshops (What a Songjiang Mill Test Actually Showed)

    I’ve spent twelve years walking factory floors around Shanghai, mostly fixing the same edge-banding failures that keep showing up on the same kinds of boards. The complaint is almost always the same: the PVC looks fine when it leaves the line, then six to eight months later the corners lift, the seam opens, and the customer starts sending photos. In our climate that pattern is rarely a mystery once you measure the substrate and watch how the adhesive actually behaves under real humidity.

    (more…)

  • Hello world!

    Welcome to WordPress. This is your first post. Edit or delete it, then start writing!